60" Polymer Braided Flexible Water Supply Connector with Garden Hose Elbow

BrassCraft B1-60DW1P 60" Polymer-Braided Dishwasher Connector – 3/8" Compression x 3/4" Female Hose Thread Elbow

The BrassCraft B1-60DW1P is a 60-inch flexible water supply connector engineered for use with residential dishwashers. It features a 3/8" compression inlet and a 3/4" female hose thread elbow outlet, commonly used for dishwasher inlet valve connections. This connector is built for long service life in high-moisture environments and confined spaces where bending and routing flexibility are essential.

The supply line incorporates a polymer-braided exterior jacket for added strength, surrounding a reinforced PVC core designed to resist pressure fatigue, kinks, and chemical degradation. It is equipped with brass compression fittings and an 8-sided pneumatic crimp for secure end termination and sealing integrity.

Features

• Connector Type: 3/8" compression x 3/4" female hose thread elbow
• Length: 60 inches
• Outer Jacket: Braided engineered polymer for flexibility and abrasion resistance
• Inner Core: Reinforced PVC for long-term reliability under pressure
• Nut Material: Brass with corrosion-resistant plating
• Crimp Type: 8-sided pneumatic crimp ensures secure nut-to-hose connection
• Sealing Components: Molded rubber washers at both ends
• Pressure Rating: Up to 125 PSI working pressure
• Temperature Range: 40°F to 140°F (4°C to 60°C)
• Compliance: Lead-free – compliant with federal and state regulations for potable water systems

Use Case

• Designed for dishwasher water supply lines
• Flexible construction allows for installation in tight or offset spaces
• Suitable for residential kitchen installations requiring a 3/8" compression supply connection

Installation Considerations

This connector is intended for use with shut-off valves featuring a 3/8" compression outlet and dishwashers with a 3/4" garden hose thread inlet. Ensure all connections are properly tightened and leak tested before placing the appliance into service. Over-tightening fittings may cause thread damage or washer deformation. Installation should conform to applicable plumbing codes.