6 inch Flexible Cap (Copper Cast Iron PVC or Steel Pipe)

QC-106 6 inch Flexible Qwik Cap – Fernco-Style Elastomer End Seal for CI, PL, STL, and COP Pipe

The QC-106 6 inch Flexible Qwik Cap is a removable elastomeric cap designed for sealing the open end of 6-inch nominal piping in non-pressurized systems. Compatible with cast iron (CI), plastic (PL), steel (STL), and copper (COP) piping, this cap provides a reliable mechanical seal in temporary or permanent termination scenarios.

Molded from elastomeric polyvinyl chloride (PVC) and secured with a stainless steel clamp, the cap resists corrosion and accommodates slight dimensional variations across pipe materials. It is designed for use in drain, waste, and vent (DWV) applications and is particularly effective in maintenance, testing, and cleanout isolation procedures.

Product Features

• ✅ Size Compatibility: Fits nominal 6 inch CI, plastic, steel, and copper piping
• ✅ Material Composition: Flexible PVC body with 300-series stainless steel clamp
• ✅ Seal Type: Mechanical, non-threaded push-on design with worm-gear clamp compression
• ✅ Temperature Range: Serviceable from -30°F to 140°F (intermittent)
• ✅ Pressure Rating: Rated for gravity flow systems; not for pressurized applications

Compliance and Approvals

• ASTM D5926 – Standard Specification for Flexible PVC Couplings
• CSA B602 – Mechanical Couplings for Drain, Waste, and Vent Systems
• UPC/IAPMO Listed – Meets plumbing code for DWV use
• Lead-Free – Complies with NSF/ANSI 372 for materials in contact with potable systems (if applicable)

Installation Guidelines

No special tools are required beyond a flat-head screwdriver or nut driver. Position the cap over the pipe end and tighten the stainless steel clamp to the manufacturer’s torque specification (typically 60 in-lbs). Ensure the sealing surface is free of debris and moisture prior to installation. This fitting is reusable and suitable for temporary service line isolation, test terminations, or permanent sealing when solvent weld or threaded caps are not practical.

Typical Applications

• Drain and sewer cleanout termination
• DWV test capping
• Temporary system isolation during repairs or inspections
• Pipe end protection during phased construction

Technical Note

Flexible end caps are not suitable for pressurized systems and should not be used where sustained internal pressure exceeds rated gravity DWV design. For permanent pressurized closures, use caps rated to applicable ASTM and ASME standards for pressure piping.

The QC-106 6 inch Flexible Qwik Cap provides a fast, code-compliant solution for terminating or isolating open pipe ends across multiple piping materials. Engineered for DWV system compatibility, ease of installation, and field reusability in both residential and commercial applications.