3/4 inch CPVC 45 Degree Street Elbow Plastic x Fitting

3/4 Inch CPVC 45 Degree Street Elbow – Street x Socket, Hot and Cold Water Applications

The 3/4 inch CPVC 45 Degree Street Elbow is designed for making angled transitions in chlorinated polyvinyl chloride pressure systems. With one spigot (street) end and one socket (slip) end, this fitting enables directional changes while minimizing additional fittings. Suitable for potable water distribution systems, it supports efficient layout and reduced joint count in both residential and commercial installations.

Performance and Application Advantages

• ✅ Material: CPVC (Chlorinated Polyvinyl Chloride) per ASTM D1784 Cell Class 23447
• ✅ Configuration: Street (spigot) x Slip (socket) ends for solvent weld installation
• ✅ Angle: 45 degrees, used to change pipe direction with minimal flow disruption
• ✅ Temperature Rating: Up to 180°F (82°C) at 100 psi, depending on system pressure and installation environment
• ✅ Standard Compliance: Manufactured in accordance with ASTM D2846 for hot and cold water systems

Installation Guidelines

This fitting should be installed using CPVC-compatible primer and solvent cement. Surfaces must be clean and dry prior to application. Apply even layers of cement to both socket and spigot ends. Allow proper curing time before pressure testing or system use. Avoid use in systems designed for compressed air or combustible gases.

Common Applications

• ✅ Potable water distribution piping systems
• ✅ Mechanical rooms and hot water recirculation systems
• ✅ Layout adjustments in residential and commercial buildings where directional change is needed

Code and Material Notes

CPVC is recognized for its corrosion resistance, mechanical strength, and compatibility with potable water. It meets lead-free requirements and is an acceptable material in IPC and UPC for hot and cold water distribution. The use of a 45-degree elbow minimizes turbulence and pressure loss compared to 90-degree fittings.