2 inch x 2 inch x 1-1/4 inch Carbon Steel 4712 RG Gas Press Reducing Tee Press x Press x Fitting

2 Inch x 2 Inch x 1-1/4 Inch Carbon Steel Press Reducing Tee – Fuel Gas Rated

The 2" x 2" x 1-1/4" Carbon Steel Press Reducing Tee is a mechanical fitting designed for fuel gas distribution systems using press-connect technology. It enables branching from a 2-inch main line down to a 1-1/4 inch outlet, providing a secure, flame-free installation solution for gas piping in residential, commercial, and light industrial settings.

Performance Characteristics

• ✅ Carbon Steel Body – Fabricated from zinc-plated carbon steel for corrosion resistance and high mechanical strength in gas service conditions.
• ✅ Press Connection Ends – Compatible with standard press tools and jaw profiles (TH, H, or V), allowing efficient assembly without welding or threading.
• ✅ HNBR Sealing Element – Factory-installed yellow hydrogenated nitrile butadiene rubber (HNBR) O-rings provide a gas-tight seal under typical operating pressures and temperatures.
• ✅ Branch Reduction – Reducing outlet simplifies pipe size transitions without separate bushings or adapters, reducing potential failure points.

Technical Specifications

• Material: Carbon steel with zinc-plated coating
• Sizes: 2" (main run) x 2" (main run) x 1-1/4" (branch)
• Connection Type: Press x Press x Press
• Seal Material: HNBR (yellow) for gas applications
• Operating Pressure: Up to 125 PSI for fuel gas systems
• Temperature Range: -40°F to 180°F (with HNBR seal)
• Compliance: ANSI LC 4, CSA-certified, ICC-compliant

Intended Use

This reducing tee is used for branching in natural gas or propane systems, including appliance feeds, distribution mains, and zone lines in multi-unit buildings. It supports consistent installation performance across both horizontal and vertical runs in fuel gas configurations.

Installation Guidance

Install using manufacturer-approved press tools and ensure proper pipe preparation, including deburring and calibration. No open flame or threading is required. Verify O-ring condition before pressing and confirm alignment to avoid deformation. This fitting is not intended for potable water systems.

The 2" x 2" x 1-1/4" Carbon Steel Press Reducing Tee is an efficient solution for professionals seeking a reliable, code-compliant gas fitting that minimizes labor while maintaining system integrity.