2 inch x 1/2 inch Black Iron Reducing Tee Female x Female x Female

2 inch x 2 inch x 1/2 inch Black Malleable Iron Tee – Threaded FPT x FPT x FPT

This 2 inch x 2 inch x 1/2 inch black malleable iron reducing tee is designed for use in threaded steel or iron pipe systems. It facilitates a branch connection from the run of a larger diameter pipe to a smaller outlet. This fitting features three female National Pipe Taper (NPT) threads and is manufactured for mechanical strength and leak-resistant performance in gas, steam, air, and non-potable water piping systems.

Made from ASTM A197 compliant malleable iron and produced in accordance with ASME B16.3 standards, the tee supports Class 150 service ratings. Its black finish indicates suitability for indoor use in dry or fuel gas applications where zinc-coated fittings are not required.

Technical Specifications

• Nominal Sizes: 2 inch x 2 inch x 1/2 inch
• Configuration: Reducing Tee – Female NPT x Female NPT x Female NPT
• Material: Black Malleable Iron (ASTM A197)
• Thread Standard: ANSI B1.20.1 (NPT)
• Pressure Rating: Class 150 (non-shock, WOG)
• Finish: Black (uncoated)

Common Applications

• • Low-pressure natural gas or propane distribution lines
• • Hydronic heating system distribution manifolds
• • Low-pressure air or vacuum systems
• • Industrial mechanical piping for steam or process gases

Installation Guidelines

All threaded joints should be assembled using PTFE tape or approved thread sealant. Over-tightening should be avoided to prevent thread distortion. Pipe runs and branches should be properly supported in accordance with applicable code requirements to reduce mechanical stress at the fitting.

Material Note

Black malleable iron is used where corrosion from external moisture is minimal, and where zinc contamination must be avoided (e.g., gas systems). For potable water or corrosive environments, galvanized or alternative materials may be required per local code.