1 inch x 1 inch x 3/4 inch Carbon Steel 4712 RG Gas Press Reducing Tee Press x Press x Fitting

1 Inch x 1 Inch x 3/4 Inch Carbon Steel Gas Press Reducing Tee – Press x Press x Press

This carbon steel reducing tee is engineered for press-to-connect installation in fuel gas systems. Designed to transition from a 1-inch main line to a 3/4-inch branch, it supports space-efficient layouts and secure press connections in high-pressure gas distribution networks. The fitting is constructed to deliver reliable performance in commercial and residential systems where durability and code compliance are critical.

Technical Specifications

• Material: Carbon Steel per ASTM A420
• Size: 1 in x 1 in x 3/4 in nominal
• Connection Type: Press x Press x Press
• Sealing Element: Factory-installed HNBR (Hydrogenated Nitrile Butadiene Rubber)
• Pressure Rating: Up to 200 psi for natural gas and propane
• Temperature Range: -40°F to 180°F
• Certifications: IAPMO/UPC, ANSI LC 4, and CSA Z662 compliant for fuel gas press fittings

Performance Characteristics

• Engineered for Gas Distribution: Suitable for both low-rise and high-demand installations
• Secure Press Technology: Delivers consistent joint integrity and eliminates the need for hot work
• Code-Compliant Transitions: Enables efficient diameter reductions while maintaining flow and pressure balance
• Non-Combustible System Compatibility: Designed for use with Schedule 10–40 carbon steel gas lines

Installation Notes

Install using a compatible pressing tool equipped with carbon steel jaws. Ensure pipe ends are cut square, deburred, and marked for insertion depth before pressing. Verify system pressure ratings prior to commissioning. Use only in gas service applications with approved pipe materials.

Typical Applications

• Natural gas and propane piping systems
• Boiler room gas distribution
• Commercial kitchen gas lines
• Retrofits and new construction in residential and multi-family dwellings

Important Notes

Not intended for potable water or chemical service. This fitting is designed specifically for fuel gas applications where press fitting methods are approved. Verify jurisdictional acceptance and ensure all local code requirements are met prior to installation.