1 inch x 1 inch x 1/2 inch Carbon Steel 411 RG Gas Press Reducing Tee Press x Press x Press

1 Inch x 1 Inch x 1/2 Inch Carbon Steel Gas Press Reducing Tee – Press x Press x Press

The Carbon Steel Gas Press Reducing Tee provides a secure and code-compliant connection point for branching 1/2 inch gas lines from a 1 inch main. This reducing tee is specifically designed for use in fuel gas distribution systems using carbon steel piping and press technology. The fitting supports press-to-connect installation, eliminating the need for welding or threading in above-ground gas applications.

Performance and Construction

• ✅ Material: Zinc-plated carbon steel for corrosion resistance in exposed indoor gas installations
• ✅ Press Connection: Three press ends designed to fit carbon steel pipe and seal via mechanically compressed HNBR sealing elements
• ✅ Sealing Element: Factory-installed yellow HNBR O-rings formulated for fuel gas compatibility
• ✅ Connection Sizes: Main line: 1 inch; Branch: 1/2 inch
• ✅ Operating Pressure: Rated for up to 125 psi in fuel gas systems (verify per project and code requirements)

Standards and Certifications

• ✅ Compliance: Conforms to ANSI LC 4 / CSA 6.32 for fuel gas press fittings
• ✅ Usage: Approved for use in natural gas and propane distribution (above-ground only)
• ✅ Operating Temperature Range: -40°F to 180°F under normal service conditions

Installation Guidelines

This fitting is installed using an approved press tool compatible with the press fitting profile. Ensure all pipe ends are properly cut, deburred, cleaned, and marked to verify full insertion depth before pressing. The fitting should only be used in systems where thermal expansion, pressure, and media are within the product's performance limits.

This reducing tee is not intended for use in underground systems unless properly protected and approved for burial. Do not substitute for potable water or compressed air unless rated and certified for such use.

Typical Applications

• Branch line connections in natural gas risers and headers
• Fuel gas distribution for appliances and mechanical equipment
• Residential and commercial pipe routing for LPG and NG systems

Material and System Compatibility

Carbon steel press fittings are chosen for their mechanical strength, ease of installation, and performance under pressurized gas conditions. The integrated HNBR seal provides reliable gas-tight performance without flame or soldering, simplifying system expansion and retrofits.