1/8 inch Square Head Galvanized Cast Iron Plug

1/8" Galvanized Cast Iron Plug – Threaded Closure for Pressure and Drain Systems

The 1/8 inch Galvanized Cast Iron Plug is a threaded pipe fitting used to seal the end of a female threaded iron pipe or fitting in pressurized or non-pressurized systems. Manufactured from cast iron and zinc-coated for corrosion resistance, this plug is suitable for use in utility piping, mechanical rooms, gas service, and industrial process lines where durability and mechanical sealing are required.

Designed in accordance with ASME B16.3 standards for malleable and cast iron threaded fittings, the plug features tapered male NPT threads for secure engagement and leak-resistant performance under normal working pressures.

Performance Characteristics

• ✅ Material: Cast iron with hot-dip galvanized coating for improved corrosion resistance in exposed or humid environments.
• ✅ Connection: 1/8" Male NPT – threads comply with ANSI/ASME B1.20.1 for tapered pipe thread applications.
• ✅ Design: Square head for wrench tightening in confined spaces or low-clearance service points.
• ✅ Service Use: Suitable for sealing unused branch outlets, test ports, or ends of temporary service lines.

Applicable Standards

• Material Specification: ASTM A-126 (gray iron) or equivalent per fitting class
• Threading Standard: ANSI/ASME B1.20.1 (NPT)
• Dimensional Standard: ASME B16.3 for threaded cast iron fittings

Installation Guidance

Use an approved thread sealant or PTFE tape compatible with the system medium. Tighten using a suitable wrench applied to the square head to avoid over-torquing. Do not overtighten into brittle materials or apply mechanical load to the plug during system operation. This plug is not intended for systems requiring soldered or welded closures.

Typical Applications

This fitting is commonly used to terminate or seal threaded connections in natural gas piping, compressed air lines, low-pressure steam systems, and water distribution piping not subject to internal corrosion. It is also used as a test point seal or during system modifications where branches are temporarily capped.

Material Note

Galvanized cast iron plugs are suitable for interior and exterior use. The zinc coating offers resistance against rust formation in atmospheric moisture, though not recommended for aggressive chemical environments or direct contact with potable water without confirming compliance with local code.

The 1/8" Galvanized Cast Iron Plug provides a durable, code-compliant solution for closing threaded system outlets in utility piping and mechanical assemblies. Its robust design and corrosion protection make it a practical choice for both new installations and maintenance work.