1/2 inch Carbon Steel 406 G 45 Degree Gas Press Elbow Press x Press

1/2" Carbon Steel 45° Press Elbow – Press-Connect Fitting for Fuel Gas and Mechanical Systems

The 1/2" 45° press elbow is a carbon steel pipe fitting designed for directional changes in press-connect piping systems. Manufactured for use with compatible press tools, this elbow provides a reliable and permanent connection for carbon steel pipe in fuel gas, hydronic heating, and other closed-loop applications. Its 45-degree angle helps reduce flow disruption and stress on piping configurations where directional offset is required.

Technical Specifications

• Material: Carbon steel (typically ASTM A420 or equivalent)
• Connection Type: Press-to-connect (M-profile press ends)
• Angle: 45 degrees
• Nominal Size: 1/2 inch
• Seal Element: HNBR O-ring for fuel gas compatibility
• Operating Pressure: Up to 200 psi (depending on system design)
• Temperature Range: -40°F to 180°F for fuel gas applications (consult manufacturer guidelines)
• Certifications: Complies with ANSI LC 4 / CSA 6.32, ICC-ES PMG, and IAPMO listings for fuel gas press fittings

Installation Notes

Compatible with carbon steel piping that conforms to ASTM A53, A106, or A135. Use a calibrated press tool with M-profile jaws approved for carbon steel fittings. Cut pipe square, deburr, mark insertion depth, and verify O-ring condition before pressing. System must be pressure tested in accordance with applicable codes after installation.

Common Applications

This 45° press elbow is typically installed in:

• Fuel gas distribution piping (natural gas or propane)
• Low-temperature hydronic heating systems
• Industrial and mechanical piping systems requiring directional changes

Material Consideration

Carbon steel press fittings are suitable for dry gas and fluid systems where corrosion control measures are in place or not required. They are not intended for potable water or aggressive chemical service unless otherwise specified. External protection (such as painting or wrapping) may be needed for exposed installations in corrosive environments.